System config WANMode=ETH WANEthPort=ethif4 defaultconnection=Internet_over_LAN # Set System Configuration so the LEDs light up properly Nat ifconfig intf=Internet_over_LAN translation=enabled
# Enable DHCP on the interface so that we might get an IPĭhcp client ifconfig intf=Internet_over_LAN metric=10 dnsmetric=10ĭhcp client rqoptions add intf=Internet_over_LAN option=dhcp-lease-timeĭhcp client rqoptions add intf=Internet_over_LAN option=dhcp-renewal-timeĭhcp client rqoptions add intf=Internet_over_LAN option=dhcp-rebinding-timeĭhcp client rqoptions add intf=Internet_over_LAN option=subnet-maskĭhcp client rqoptions add intf=Internet_over_LAN option=default-routersĭhcp client rqoptions add intf=Internet_over_LAN option=domain-name-serversĭhcp client ifattach intf=Internet_over_LAN Ip ifconfig intf=Internet_over_LAN status=up Ip ifadd intf=Internet_over_LAN dest=ethwan # Add a new logical interface and connect to physical interfaceĮth ifconfig intf=ethwan dest=ethif4 wan=enabled # Remove Desired Ethernet Port (except Port 1 that cannot be removed) from Ethernet Bridge # Disable WAN sensing to prevent it from interfering issue the following commands at the router's CLI (line with # indicates a comment and not a command)Įnv set var=CONF_PROVIDER value=”Manual Internet over LAN”Įnv set var=CONF_DESCRIPTION value=”IPoE”Įnv set var=CONF_SERVICE value=”Internet over LAN” Usually username will be Administrator with a blank password after a reset use the default username and password usually printed on the sticker at the back of the router Like if Telnet Client feature is installed in Windows OS, then we can use Command Prompt However, if we want more control over the router, we can use the CLI to convert any LAN port except Port 1 into a WAN ( IPoE) port like shown below: Note: In order to change settings for the TG582n while functioning as such, one may (temporarily) need to set Static IP (like IP 192.168.1.64, subnet 255.255.255.0 and gateway 192.168.1.254) to login to the web interface! plug the LAN cable (for internet) from other router into the Ethernet Port 4 indicated by the sticker wait for the router to settle down after the reset reset the router either via the web interface or via holding the hardware reset button pressed via pin for some time
0 kommentar(er)
